Contax SW 2524 - REV A Instalační příručka stáhnout pdf (Strana 61)

Charger Specifications

975-0637-01-01 Rev B 2–3

This guide for use by qualified personnel only

Charger Specifications

NOTE: All charging specifications are at nominal conditions: ambient

temperature of 25 °C, 230 VAC, 50 Hz input, unless otherwise specified.

DC Output SW 2524 230 SW 4024 230

Maximum output current 65 A 90 A

Nominal output voltage 24 VDC 24 VDC

Charging output voltage operation

range

12.0–32.0 VDC 12.0–32.0 VDC

Equalization cycle Automatic, Manual

by SCP

Automatic, Manual

by SCP

Optimal charging efficiency 90% 90%

Dead battery charge voltage > 12.0 VDC > 12.0 VDC

Charging methods (two settings)

Three-stage charge (Bulk, Absorption, Float)

[default]

Two-stage charge (Bulk, Absorption)

Without a battery temperature sensor

(three settings)

Cool 10 °C

Warm 25 °C [default]

Hot 40 °C

With a battery temperature sensor

(provided)

The temperature compensation

coefficients on a 24-volt battery

are as follows:

Flooded: 54 mV × (25 °C – BTS °C)

Gel: 54 mV × (25 °C – BTS °C)

AGM: 42 mV × (25 °C – BTS °C)

AC Input SW 2524 230 SW 4024 230

Power factor at full charge rate > 0.98 > 0.98

Current 10.6 A 14 A

Voltage 230 VAC 230 VAC

Voltage range 170–270 VAC 170–270 VAC

Frequency range 40

–

70Hz 40

–

70 Hz

AC INPUT Connection

Single-Phase (L, N) Single-Phase (L, N)

Circuit breaker (resettable) 30 A 30 A

ConextSWEUROInstallationGuide.book Page 3 Wednesday, December 5, 2012 10:55 AM

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 73 74

Komentáře k této Příručce

Žádné komentáře

Contax SW 2524 - REV A Instalační příručka Strana 61

Komentáře k této Příručce

Související produkty a manuály pro Napájecí adaptéry a střídače Contax SW 2524 - REV A