Contax SW 2524 - REV A Instalační příručka stáhnout pdf (Strana 43)

Inverter/Charger Installation

975-0639-01-01 Rev A 1–25

This guide for use by qualified personnel only

Figure 1-12 Installing the DC Switchgear

mounting hole

copper bus bar

connector (+)

pre-cut

mounting hole

positive (+) DC

terminal (red)

copper bus bar

connector (–)

pre-cut

mounting hole

negative (–) DC

terminal (black)

copper bus bar

connector

flat washer

nut

DC terminal

(1) Unpack the DC

Switchgear from its box, if

not already.

(2) Prepare four #10 (M5)

machine screws. Use two

screws to secure the DC

Switchgear to the installation

brackets of the Conext SW

and two screws to secure

the connecting bracket. The

connecting bracket attaches

to the Conext SW and DC

Switchgear.

(3) Remove the nuts and

washers from the inverter/

charger’s DC terminals, if

present.

(4) Position the DC

Switchgear next to the

inverter/charger carefully

aligning the mounting holes

with the pre-cut mounting

holes on the installation

bracket and the copper bus

bar connectors with the

inverter/charger’s DC

terminals.

(5) Fasten the screws to the

mounting holes on the DC

Switchgear with the pre-cut

mounting holes on the

installation bracket of the

inverter/charger.

(6) Fasten the screws to the

connecting bracket to join

the DC Switchgear and the

Conext SW together.

(7) Fasten the nuts and

washers of the inverter/

charger’s DC terminal bolts

to secure the copper bus

bars.

connecting

bracket

(5)

(6)

(7)

ConextSW-NA-InstallationGuide.book Page 25 Thursday, December 20, 2012 2:05 PM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 75 76

Komentáře k této Příručce

Žádné komentáře

Contax SW 2524 - REV A Instalační příručka Strana 43

Komentáře k této Příručce

Související produkty a manuály pro Napájecí adaptéry a střídače Contax SW 2524 - REV A