Contax POWER MODULE SYSTEM Uživatelský manuál stáhnout pdf (Strana 14)

Redline

D.13

Pulsar S

Performance

PLS + PLS + C

(4)

PLS + 16 PLS + 32

PLS + SA & SB

PLS + PU 16 PLS + C 16 PLS + C 32

Rated current (acc. to IEC 669-2-3)

250VAC (1 & 2 pole) / 400VAC (3 & 4 pole) A 16 32 16 16 16 32

Direct Current (at 30 VDC) A 16 16 16 16 16 16

Number of poles 1 → 41 → 4 2 1 → 41 → 31 → 3

Contacts

NO 1 → 41 → 4 2 1 → 41 → 31 → 3

Changeover ("m") 1 → 4- -1 → 41 → 3-

NO + NC 1+1 / 2+2 - - 1+1 / 2+2 - -

Width (in 17.8mm DIN modules)

1 P Mod. 1 1 - 1 1 1

2 P Mod. 1 1 1 1 1½ 1½

3 P Mod. 2 2 - 2 2 2

4 P Mod. 2 2 - 2 - -

Coil speciﬁ cations

Supply voltage : DC/AC ratio

(1)

0.5 / 1 0.5 / 1 0.5 / 1 0.5 / 1 0.5 / 1 0.5 / 1

Supply voltage range (in % of Un) % 90-110 90-110 90-110 90-110 90-110 90-110

Coil pick-up power (AC) 1P & 2P VA 14.5 16.0 14.5 4.8 14.5 14.5

3P & 4P VA 14.5 16.0 - 8.0 16.0 16.0

Coil power loss - AC 1P & 2P VA 11.0 11.5 11.0 3.2 11.0 14.5

3P & 4P VA 11.0 11.5 - 6.0 11.0 16.0

Coil power loss - DC 1P & 2P W 7.5 8.0 7.5 2.9 12.5 12.5

3P & 4P W 7.5 8.0 - 5.4 14.5 14.5

Maximum coil holding voltage time

(2) (2) (2)

unlimited

(2) (2)

Impulse times

Minimum impulse time (under Un) sec. 0.050 0.050 0.050 0.050 0.100 0.100

Minimum impulse time (90% Un) sec. 0.100 0.100 0.100 0.100 0.100 0.100

Minimum time between impulses sec. 0.150 0.150 0.150 0.150 0.150 0.150

Maximum number of impulses per mn 250 250 250 250 250 250

Lifetime (in number of operations)

(3)

Electrical (in AC-1 - At full load)

(4)

4 x 10

3 x 10

2 x 10

4 x 10

3 x 10

Mechanical 2 x 10

2 x 10

1 x 10

2 x 10

Load speciﬁ cations

Maximum load AC-1 per phase A 20 32 20 20 20 32

Maximum load DC (30VDC) A 16 16 16 16 16 16

Minimum load per phase (under 5V) W 2 2 2 2 2 2

Short-circuit fuse protection A 20 32 20 20 20 32

Maximum lamp load (10

operations/h)

Incandescence & halogen (40 to 200 W lamps) W 3,000 4,000 3,000 3,000 3,000 4,000

Fluorescence, compensated (cos

= 0.9)

Serial compensation VA 3,000 4,000 3,000 3,000 3,000 4,000

Parallel compensation VA 2,500 3,200 2,500 2,500 2,500 3,200

Fluorescence, non compensated (cos

= 0.5)

VA 1,800 2,200 1,800 1,800 1,800 2,200

Maximum number of push-buttons

Non illuminated push-buttons unlimited unlimited unlimited unlimited unlimited unlimited

Luminous push-buttons (0.6mA)

4 terminals unlimited unlimited unlimited unlimited unlimited unlimited

3 terminals Without compensator 8 8 8 6 8 8

1 compensator 18 18 18 15 27 27

2 compensators 45 45 45 38 43 43

General speciﬁ cations

Power contact add-on yes yes no no no no

Auxiliary contact add-on (PLS / CTX R) yes yes no yes yes yes

Need for spacer

(2)

yes yes yes no yes yes

DIN rail mounting yes yes yes yes yes yes

2-position DIN rail lock yes yes yes yes yes yes

2-position handle yes yes no yes yes yes

Indicator of contact position yes yes yes yes yes yes

Clamping terminals yes yes yes yes yes yes

Unlosable screws yes yes yes yes yes yes

Sealable terminals (coil and load) yes yes yes yes yes yes

Cable cross section (Ø min/max) Coil mm² 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 10

Load 1P-3P & 4P mm² 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 10

Load 2P mm² 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 10 1.5 / 6 1.5 / 10

Maximum torque on terminals Nm 1 1 1 1 1 1

Ambient temperature at installation point (min./max.) °C -20 / +45 -20 / +45 -20 / +45 -20 / +45 -20 / +45 -20 / +45

(1) For all impulse relays, DC supply voltage = AC supply voltage x DC/AC ratio, except for 8 VAC and 115VAC (48 VDC)

(2) Whenever the normal use of the impulse relay integrates a permanent coil working, use of a spacer is required on both sides. Make sure that the duty

factor allows the device to come back to the ambient temperature (not required for PLS PU)

(3) 1 cycle = 2 operations per pole (closing + opening)

(4) For any central command installation, a PLS SG module per phase must be installed in order to protect the coils against overvoltages

.13

New

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

Komentáře k této Příručce

Žádné komentáře

Contax POWER MODULE SYSTEM Uživatelský manuál Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Napájecí adaptéry a střídače Contax POWER MODULE SYSTEM